lahydro.blogg.se

Problem: the CPU cooler is not detected by BIOS, showing 0 rpm in Hardware Monitor.

It is a PWM fan and it is set as such in BIOS. The CPU cooler is a Noctua NH-U12S, it is plugged into the CPU connector (not pump or ext) and it does spin just fine. The location of the battery reset hole might differ by the model, please refer to the product manualģ.Just built a new system using MSI PRO Z690-A WIFI DDR5. Some of the model might not have the battery reset hole, please remove the power adapter and the battery (if applicable, differ by model) for 15 seconds and place it backĢ.

Use a paper clip to insert into the battery reset hole at the bottom of the unit.ġ. If the DGPU is disable, please launch a 3D software (such as 3D game) to enable the DGPU and increase the system loading. Louder than average noise while Cooler Boosts is operation is normal since, during that time, the fan(s) run at the highest speeds possible, resulting in greater airflow.Ĭheck DGPU is enable (the power indicator will show orange when the DGPU is enable). (This is only for the models with the Cooler Boost button.) If the Cooler Boost function is enabled, please press the Cooler Boost button to turn the function off and check to see if the noise still remains. This is a normal behavior.Ĭheck to see if the “Cooler Boost” function is enabled. If system temperature is low, the fan will stop or the fan speed will turn slow. Launch the "MSI Dragon Center" and click "Details" under the CPU/GPU to check current temperature status. If there is no any operating sound from thermal fan, please contact with MSI customer service directly. When pressing the power button to boot up the notebook, thermal fan will start running at this moment. Your notebook might equip with single or multi thermal fans. (Warning): MSI offer different thermal design for each of generation. Please follow the steps below to confirm.